Make your patterns are beautiful
by n1k-o
Thus, the musicians, this infa may be useful to you and only you
:) Soon it might come in handy already 'mature' musicians
probably just for the aesthetic pleasure of contemplation of his
tracks (there is;) Practically, it is convenient in that
your tracks will weigh a few tens of bytes less.
I did a regular table volume, thus, became
may result in volume in the sample and the volume in the
pattern of harmonious combination of not using every once in a
pattern too much piling up the volume. In other words - give all
volume to a common denominator, changing the volume only in the
sample, sometimes it is easier to make a few 'fading' samples,
rather than every time to change values in the pattern, this
way, spoke alone coder (see 'TB';)
in the process it looks like there is a fragment,
which one Semple used 'F' and 'A' volume or
there is a loud samples, which are constantly muted, the data
cases for the convenience can all be subsumed under a single
volume 'F', but when the track is already written, and all
'played' remake samples, can cause some difficulty, ie,
changing values Volume on the ear, risking a mistake in
choosing the volume in samples 1 or 2 values:) In this case it
may be useful table volume, which should be used as a 'debugger'
to sample or convert their volume:)
FEDCBA987654321
:::::::::::::::
: 1:11111111 .......
: 2:222211111111 ... ; Alco, correct me
: 3:3322222111111 .. And if I'm in something wrong:)
: 4:44333322221111. ; Table is valid for pt3.x
: 5:55444333222111.
: 6:66554443322211.
: 7:77665544332211.
: 8:877665544332211
: 9:988776554432211
s: A: a99877655433211
a: B: baa987765443211
m: C: cbaa98766543221
p: D: dcbaa9876543321
l: E: edcba9877654321
e: F: fedcba987654321
:::::::::::::::
channel
Favor of this table, for example, I have written sample 'x', in
where the sound was too loud and always me
muted, say, the volume 'C', as a result, the channel I
-Excess-volume 'C', after which it is necessary to put
current for the channel volume, say, 'F'. Mutes
volume in the sample 'x' to the volume level 'C' and in the
channel now You can not put the extra volume of 'C':)
For example, the volume of the sample 'x' I have this:
F, E, D, C, B, A - to me it should be lowered to the level of
volume 'C' in channel.
Consider the table: the volume of 'F' in the sample, at
gomkosti 'C' in channel = volume 'C' - this is the desired
volume, rest process is the same for all volume levels; 'E' =
'B'; 'D' = 'A'; 'C' = A '; 'B' = '9 ';' A '= '8'.
Now, musicians, rather Forget everything that I've written here,
alone because stupidity:) Write everything as written in the
past, think only about music, technique remember at the moment
'Fixing' the track, if anyone at all, there exist
moments%).
