NEW BRIGHT
(C) Gris
Hello, dear readers. With you again I, Gris. Since our
graduate zhelezyachnikam to log no the case, you'll have to
settle in this section with all sorts of delusions and
little idea who had settled in my unencumbered
special knowledge in the head.
Let's start. The essence of this refinement is very simple:
instead of Flash and the general brightness of the ink and
paper we get for each individual brilliance. Thus, the palette
of Spectrum becomes "полноценношестнадцатицветной.
This innovation will enrich the range of color transitions and
facilitate their establishment. I I think it's more practical
than the notorious 7MHz instead of 2 Hz at FLASH, where all
rich 128-color palette simply can not be used to create a
normal quality image.
To convert the video controller
should:
1. Split the signal BRIGHT, walking and
on PAPER, and INK: figure out the scheme
Your Computer literacy, where the data bit D6
(BRIGHT) "runs" in the video controller,
trace his "journey" through
multiplexers (indicated on the diagram MX
or MUX) to the point, which unites
D0, D1, D2 (INK) and D3, D4, D5 (PAPER);
D6 only way to leave the group D0, D1,
D2, from the D3, D4, D5 - "to separate."
2. Traced in this way to
is bit D7 (FLASH). He has to "stretch" in the logical element
"AND" or "AND-NOT" FLASH is interfaced with the signal, which
determines the frequency of blinking (itself FLASH only is
allowed to blink), tear FLASH from the logical element and
apply for our scheme (inputs A2, B1), to submit to it as BRIGHT
(inputs A0, A1, B0), the input B2 KP11 lodge land.
3. Output Y0
KP11 can be anywhere
not connected,
as BRIGHT on
ink we do not
cut (I just
driven, and now
do not want to redraw).
The output signal of
Y1 to file
back to where you
cut BRIGHT.
The output signal of
Y2 must be submitted to the
entrance of the gate, where you cut
FLASH.
4. Now all you have to solder
toggle switch, which you will turn on / off completion. In the
open position at the input S is high, in a closed low.
Depending on the position toggle switch in the video controller
will be fed a standard or a new combination of signals.
