Iron connect a second drive ;-) 08
WW: So it's not such a stupid question, and if people
ask how to do it / in my time, I also did not know.
Since I just recently pull up his Drive: B, then the memory
tell / While "Iron" - not my element.
Most Chapter B / R, it must be powerful / Baytovski - the two
are not pull /, well, everything else is easier as dirt:
<- Built to Drive: A
<- This was
That's right ->
* Built-in Drive: B->
The wire going to the controller TR-DOS
* It is used exactly the same connector as the stands Drive: A,
open it and see a lot of "needles" on which to impale veins
wire, just below the first, as shown in the diagram / if not
know how to open the socket Drive: A /, the main thing - it is
not "Fluff" / all should be parallel to Drive: A /. Exactly the
same is the case with the connector on food, soldered wire on
connector Food drive: A and solder them to the second connector
to the same contacts / mix hard, just three wires. Now
paste them to a place / old connector still drive
: A new, appropriately: At. Now jumpers, drives can
be different, but all of them has "pins" which are
next / they are usually 8 (4 for two), but there are more (in
Bulgarian with I have them 10). Look where standing on your
first drive jumper / she is always on the edge / and exactly
the same place on the second drive, but not the second kantakt:
Drive: A Drive: B
■ ■ ■ ■
■ ■ ■ ■
■ ■> ■ ■
■ ■ <■ ■
Jumpers / can be a piece of foil /
That's all problemmy.Samoe complicated - it is right nakalot
veins the jack / I got the first time, Ars - witness.
I hope I have described all popular.
