load kernel is-dos.

Immediately click on RESET, All!

There is is-dos recorded on the screw... There is its core (inside the screw driver)
recorded
with the command sv.com. We need to somehow download and run it. There is a problem - all
boot
disks with is-dos are killed! :-( That is, the isdos is only on the screw and there is a kernel on a floppy disk
and that’s all.
I will not be engaged in rewriting images from any emulators on the PC under any
case.

I guess that the kernel is launched at its boot address, but there you need
to know the address
to which the transition via rst 0x10 should be set, and this address apparently
it is taken
from a bootloader that I don’t have!

Any suggestions? I just want to launch from STS somehow.