Monitor Kodis-M.
ZXNet echo conference «real.speccy»
A friend bought a Kodis-M monitor. You need the connector pinout and connection features, if any. Will connect to Pro.
Sincerely, Alex from FFC COMPUTERS.
>E-MAIL: asde...@softhome.net ICQ: #13064553
09 January 2000 you wrote here:
AL> An acquaintance bought a Kodis-M monitor. You need the connector pinout and connection features
AL>, if any. It will be connected to Pro.
1 - GND
2 - GND
3 - R
4 - G
5 - B
6 - I
8 - HS
9 - VS
Input - KR531LH1, with resistors 330 Ohm to +5V and 470 Ohm to ground.
All the best.
Roman.
Well, I have such a monitor, the first thing that went out was the b/p...
DJ.SERG/ACL I bought a subzh here not long ago, a week later... the same symptoms...
If I’m not confusing it, the connector is like this...
K C +12 I
o o o o
o o o o o
Gr R G B
Explanations: K & C - separately vertical and horizontal scan
I-intensity, Gr-ground
In essence, this is the same standard CGA monitor, here’s what about it written...
1.GND
2.GND
3.RED
4.GREEN
5.BLUE
6.Intensiv.
7.Reserved
8.+H.Sync.
9.+V.Sync.
As for 8 and 9, what should be there (+ or -) I won’t say, because I don’t remember... we have to
experimentally. By the way, I would also include the levels of
RGB signals as a connection feature; it took a long time to select them... because various
glitches resulted :) Well, on PROFI I don’t know, maybe it wasn’t necessary...
AL> Sincerely, Alex from FFC COMPUTERS.
C ya in nE>
>E-MAIL: asde...@softhome.net ICQ: #13064553