F.I.R.E. — ZXNet «spbzxnet.games»

From goodboy To All 20 January 2007

Hello John North you need the #FF port, the screen update is connected to it, in principle it can be replaced delay (which is what they did), but it will most likely flicker.

From Vasya Popov To All 20 January 2007

Hello, All Has anyone run it in real life? For me on Profik it only works up to the menu, but at startup it freezes :( Maybe she needs something? FF port or something else? Tell me, please.

From Vasya Popov To All 20 January 2007

Hello, goodboy goo> you need the #FF port, the screen update is connected to it, in principle it is possible goo> replace with a delay (which is what we did), but it will most likely flicker. I see... I'll think about it.

From Mark Antonov To All 21 January 2007

Hello John North On the profile, 8 resistors are allocated for the FF port, which are usually not soldered in. on in fact, one resistor is enough..

From Vasya Popov To All 24 January 2007

Hello, The Exploited The> on the profile, 8 resistors are allocated for the FF port Apparently this means the U57 matrix (for version 4). I actually have them. only for some reason they are cut off on one side :( I'll keep poking around now...

From Vasya Popov To All 25 January 2007

Hello John North Apparently they dug into my Profik's board thoroughly before I did... The FF port is not installed, or rather it is installed, but not as it should be... F.I.R.E. started. but the sprites are shaking. put it on the switch. Luckily there is still room for them. At the same time, I paused the hardware (via WAIT). Now I have as many as 7 switches :)