vga

Greetings, All! people, pls post again the pinout of the vga connector (I want Monique connect). better in soap :) With best wishes, Alex Udotoff.

Hello Alex! 31 Mar 03 01:11, Alex Udotoff -> All: AU> people, pls post again the pinout of the vga connector (I want AU> monique connect). better in soap :) Spectrum requires CGA or EGA, not VGA... C.G.A. No. Signal 1 Ground 2 Ground 3 N/C or RED 4 N/C or GREEN 5 N/C or BLUE 6 Intensity 7 Video (NTSC Video on some clone boards) 8 Horizontal Drive 9 Vertical Drive E.G.A. No. Signal 1 Ground 2 Secondary Red 3 Primary Red 4 Primary Green 5 Primary Blue 6 Secondary Green/Intensity 7 Secondary Blue/Mono Video 8 Horizontal Drive 9 Vertical Drive VGA No. Signal 1 Red Video 2 Green Video 3 Blue Video 4 Monitor ID - Bit 2 5 Ground 6 Red Ground 7 Green Ground 8 Blue Ground 9 [KEY] 10 Sync Ground 11 Monitor ID - Bit 1 12 Monitor ID - Bit 0 13 Horizontal Sync 14 Vertical Sync 15 N/C (Reserved) Best regards, Evgeniy.

Press RESET immediately, Alex! 31 Mar 03 23:44, Alex Udotoff wrote to Eugene Palenock: EP>> 4 Monitor ID - Bit 2 AU> ^^^^^^^^^^^^^^^^^^^^ EP>> 11 Monitor ID - Bit 1 AU> ^^^^^^^^^^^^^^^^^^^^^ EP>> 12 Monitor ID - Bit 0 AU> ^^^^^^^^^^^^^^^^^^^^^ AU> can you tell me more about these signals? Identification of the monitor by the video adapter. Signal from the monitor connected to the common wire or not connected anywhere (depending on the type monitor). Currently not used in any way. Monochrome monitors determined by the video adapter by the absence of load (75 ohms) on the blue contact and red colors (in this case, green is used as a brightness signal). Modern monitors use the DDC serial bus for identification, then there is I2C (pin 9 - power supply for the monitor memory chip, 12 - SDA, 15 - SCL, 5 contact - x.z., like a common wire). VGA monitor horizontal frequency 15.6KHz (from Spectrum) most likely not will pull, or turn off (if it’s more or less modern), or there will be a breakdown synchronization