DIN instead of СНП58

Hello, maximk 31 distance between contacts multiplied by 0.04 mm, the difference is 1.24 mm. If you start moving the contacts away from the center (0.62 mm to the edge) it should be fine turn out. At least we had such connectors on our PBX, everything went in with a bang DIN-СНП.

Hello, All But no one has tried, is there any way to manage to fit one into the other? Those. at In my profi, the system connector is routed to SHP58-64 (plug). And find a steam room I can’t fit my own socket... Maybe DIN 41612 will fit? And I really want to connect. I don’t like wires, I try to do everything on connectors

Hello, do_se > At least we had such connectors on our PBX, everything went in with a bang > DIN-СНП Thank you. It wasn’t the theory that interested me (I already did the math about 1.24 myself :) ), but practice. But since it’s been done, I’ll try.

Hello, kgbplus Well, it’s just an ordinary dance with 2.54 and 2.5 mm... If the legs can bend - cheers. Personally, I tried to put the IDC34 into the board, but I was not entirely successful. Because IDC's legs are quite thick and they just start from the very The connector comes out when you start pressing harder. In addition, the diameter of the legs slightly smaller than the diameter of the holes in the board, i.e. they even if they were step by step 2.5 would have been difficult to fit. Once again, in case it’s not clear. We are talking about a ready-made “Soviet” board, which is made under 2.5 mm. And you need to screw additional things from imported components that meet the standard 2.54... kgbplus That is “fitted”: just this gray DIN http://www.platan.ru/pdf/00756.pdf was paired with SHP58???

Hello, maximk I may not understand something, but it always seemed to me that it was the same thing. Always I ordered DIN connectors from the store and they fit perfectly.