Christmas tree sticks and diagrams...
ZXNet echo conference «hardware.zx»
Hello fan
there was an article in the black crow. one person (by the way, it happens on the forum) took it
mother and adapted the slots for spec. at the same time having done a lot of work - so that Isa
the slots fully matched the zx bus, I had to drill holes -
some legs are in contact with the ground and nutrition in the inner layers
Hello, Mikka_A
Mik> The gods heard my prayers..... :v2_clapp;
Mik>;
Mik> Yes, friends! I want to cram this into the Spectrum, that’s why I’m writing on
Mik> Spectrum forum, not on the pisyukov forum....:v2_lol; :v2_yahoo:;
Mik>
Mik>
Mik>
Mik>
Mik> this is exactly what I want to do.
Mik> Understand which tires cross so that you can cut everything if necessary
Mik> solder and so on so as not to block the expansion card with mgtfom
Mik> slots.
Have you forgotten about buffering? And the pitch of contacts for ISA is slightly different than for
our Soviet connectors, which we usually installed in specs.
Apparently the point is that we have centimeter measurements, and they have inch measurements. Aztali
people, there is no need to measure at the elbows or at the kneecaps. :)
Hello Mike
Mik> Have you forgotten about buffering? And the step of contacts for ISA is slightly different
Mik> than our Soviet connectors, which are usually used in specs
Mik> was installed here. Apparently the point is that we have a dimension
Mik> is centimeter, but theirs is inch. Aztali people, there’s no point in measuring your elbows
Mik> or in the kneecaps. :)
I took it into account of course.
in addition to the planar connector on the scorpion, as far as you probably know, there are holes
under the needle connector.
An L-shaped needle connector is soldered into it.
The buffer is soldered on the breadboard.
An L-shaped ISA connector is soldered into it.... and I will be happy.
Kamile's map has an inch pitch.
my man-made creatures are also a step under Isa
well, smuk also works in Isa, but with “fine” tuning... :v2_wink2:
Hello fan
fan> Just call, we’ll handle the incident, cut off the unnecessary, I don’t think that anyone
fan> will make a multi-layered Christmas tree with tracks inside.
The gods heard my prayers..... :v2_clapp;
Yes, friends!; I want to cram this into the Spectrum, that’s why I’m writing in Spectrum
forum, not on pisyukov's....:v2_lol; :v2_yahoo:;
The> had to drill holes - some of the legs are in contact with the ground and
The> power supply in the inner layers
that's exactly what I want to do.
Understand which tires cross in order to cut everything, if necessary, solder and
etc. so as not to block the slot expansion card with mgtfom.