Zx-Asm 3.10

Hello, All! I recently saw the following text: ZASM 3.10 full, (C) Rubtsov, Afendikov ───────────────────────────────────── Latest arrival! Purchased from official distributor - Maxx. A sea of possibilities, the most suitable re- editor for editing KrNews articles! Moreover, this is the coolest editor for set of bells and whistles. Since the disk is appeared with me only today (05.15.99), then a more complete description will be sooner just in the next issue of KrNews. [...] It turns out that the full version 3.10 has finally been released? Can anyone confirm this information? All the best, Kirill.

Greetings, Kirill! Somehow Sat 17 Jul 1999 Kirill Smelkov and Kirill Frolov we talked about Zx-Asm 3.10. KF>> BUT IT DOES NOT DISTRIBUTE. Written in ZX.SPECTRUM KF>> a person familiar with one of the authors of the subject, and this is the case KF>> it was a long time ago. KS> Exactly, that's a long time ago. Pay attention to the date indicated in KS> my previous message (05.15.99). The whole thing happened KS> two KS> months ago, maybe something good happened :) In Minsk there is a damn fancy one... There is an overlay system, there are even built-in games :) As I looked, the printer there is sophisticated, therefore request to ALL: give some thread to the doc about ZX-LPRINT. This is the only system supported there, so I went tinkering with the driver and saw that instead of the procedure port initialization (if we take ZX-WORD as a basis introduction to drivers) procedure for polling the 7th bit port #7B, apparently a poll on BUSY or something else, and during the transfer procedure the byte from register A is thrown out to ports #7B, #FB. Since with ZX-LPRINT I generally I don’t know, I ask knowledgeable people to give me the layout ports, bits, so that I could get it to print through BB55. And if anyone has already done this, please send me the driver... Thanks in advance.Valeriy Kovalev aka EQUATOR was here