__________________________________________
REPAIR
Poor reading a floppy disk.
(C) Wild / oHg
The reason may be the fault circuit
phase adjustment. Phase adjustment circuits assembled on chips
D92 and D93. Verification is performed without IC
1818VG93. Check the flow of impulses
4 MHz to the element D93 / 3. Connect the drive, insert a
floppy disk with the recording, lower drive heads. Check
transmission RDD pulses with the drive to contact A21
connector, then D92/2-D92/5-D85/8. You should see a pulse
frequency of about 4 MHz, which should appear on the findings
of D93 / 9, D93/11 and D90/27. Now slow down a finger motor
drive - in this case the pulse duration on the findings of D92,
D93, D90/27 should vary depending on the
engine speed. If so,
the scheme of the phase adjustment is working properly. Cause
of poor readers can be insufficient duration of the pulses
with a flip-flop D92. Then increase the capacity
capacitor C1 between common wire and the terminal element D92 /
5. You can also change conversion factor circuits D93. For
This cut output D93 / 3 of all the wires and switch to +5 V.
