Aspect #03 10 января 1998

Железо

Maker - Modernization of the soldering iron.

         Modernization of the soldering iron.


          (C) Igor Krauklis, 1998



   If you often have to work with
board, then you've probably noticed that the sting of a 
soldering iron is too thick, but I wanted would be smaller, but 
narrower ... 

   I propose to make a simple refinement
my hot friend "to the desired
size, not obtachivaya his file.

   So, we go from words to deeds. You
pull out (pull out, steal;) otkudanubud 7 ... 10 inches of 
copper wire section 1 ... 3 millimeters. Then, clear

its a file, start winding around the soldering tip,
vobschem trying to do anything should like the picture.
Cut the copper to provloku
distance of one centimeter from the
the end of the soldering tip, and attached
s cone-shaped or spatula.
After that tin "zhaltse, and work at your leisure! :)))